Menvier Security TS790+ Dokumentacja Pobierz pdf (Strona 59)

TS790+ & TS900+ Installation Manual Appendices

Appendices

Contact ID Extended Reporting

Contact ID extended reporting is a new format

which when used with the DC58 or DC58M can

be used to report circuit ID data, user ID etc. In

order to used this format the DC58/DC58M must

be plugged on to the control panel and must

also be programmed to report “Extended

Format” (refer to the instructions supplied with

the DC58/DC58M). The central station alarm

receiver must also be capable of receiving

“Contact ID extended Format”.

Contact ID Reporting takes the following format:

CCCC Q EEE GG ZZZ where:

Customer account number.

Event qualifier, where E = new event (1) and R

= restore (3).

Event code (see table below).

Always 00.

Circuit/Contact ID number reporting the alarm

(001-056), or user number (001-031) for

open/close reports. System status messages

(Mains Fail, Walk Test, etc.) contain zeros in the

ZZZ location.

Code Description

110 Fire alarm

120 Panic (PA Code) alarm

121 Duress alarm

122 Silent PA alarm

123 Audible PA alarm

130 *Intruder alarm

134 Entry alarm

135 24 Hour alarm

137 Equipment tamper alarm

139 Confirmed alarm

150 Auxiliary alarm

Code Description

301 Mains failure

302 Low system battery

305 System reset (on-site or factory)

309 Battery test failure

382 Node or Remote removed

401 Open / Close by user

406 Alarm cancelled

409 Open / Close by keyswitch

411 Call-back requested (Lineload)

412 Successful download access

413 Unsuccessful download access

465 Restore PA

570 Circuits omitted

572 24 Hour circuits omitted

573 Cct "Actively" omitted

627 Engineer program mode selected

628 Engineer program mode cancelled

Contact ID Event Codes

*Becomes CCT Tamper if Engineer menu 1.9

option 30 is set to "Tamper is Burg".

Resetting the Engineers passcode

If the installation engineer has inadvertently

changed the engineers passcode or the

passcode has been forgotten, the passcode

can be reset back to 1234 without losing any

other programmed data. This procedure can

only be used providing a user passcode is

available:

1. Ensure that the system is unset and a user

passcode is available.

2. Remove the cover from the control panel,

this will cause a "Panel Lid tamper" alarm.

3. Ask the user to enter their passcode to

silence the alarm.

4. Place the blade of a small screwdriver

between the pins labelled "FACTORY RESET".

A multi-tone sound indicates the engineers

passcode has been reset.

5. Replace the control panel cover. At the

remote keypad enter 1234. The display will

show “Engineers Menu 1". To change the

engineer’s passcode see ”Change

Passcode” on page 40.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 69 70

Komentarze do niniejszej Instrukcji

Brak uwag