Menvier Security TS700 Dokumentacja Pobierz pdf (Strona 55)

Appendices

Point ID Extended Reporting

Point ID extended reporting is a new format which

when used with the DC58 or DC58M can be used

toreportcircuitIDdata,userIDetc.Inordertoused

this format the DC58/DC58M must be plugged on

to the control panel and must also be

programmedtoreport“Extended Format”(referto

the instructions supplied with the DC58/DC58M).

The central station alarm receiver must also be

capable of receiving “Point ID extended Format”.

Point ID Reporting takes the following format:

CCCC Q EEE GG ZZZ where:

CCCC Customer account number.

Q Event qualifier, where E = new event (1)

and R = restore (3).

EEE Event code (see table below).

GG Always 00.

ZZZ Circuit/Point ID number reporting the

alarm (001-056), or user number

(001-031) for open/close reports. System

status messages (Mains Fail, Walk Test,

etc.) contain zeros in the ZZZ location.

Code Description

110 Fire alarm

120 Panic (PA Code) alarm

121 Duress alarm

122 Silent PA alarm

123 Audible PA alarm

130 Intruder alarm

134 Entry alarm

135 24 Hour alarm

137 Equipment tamper alarm

150 Auxiliary alarm

301 Mains failure

302 Low system battery

305 System reset (on-site or factory)

309 Battery test failure

382 Node or Remote removed

383 Circuit tamper

Code Description

401 Open / Close by user

406 Alarm cancelled

409 Open / Close by keyswitch

411 Call-back requested (Lineload)

412 Successful download access

413 Unsuccessful download access

570 Circuits omitted

572 24 Hour circuits omitted

601 Manual test trigger

602 Timed test call

607 Walk test mode selected

625 Date or time changed

627 Engineer program mode selected

628 Engineer program mode cancelled

382 Node or remote removed

Point ID Event Codes

Resetting the Engineers passcode

If the installation engineer has inadvertently

changed the engineers passcode or the

passcode has been forgotten, the passcode can

be reset back to 1234 without losing any other

programmed data. This procedure can only be

used providing a user passcode is available:

1. Ensure that the system is unset and a user

passcode is available.

2. Remove the cover from the control panel, this

will cause a "Panel Lid tamper" alarm.

3. Ask the user to enter their passcode to silence

the alarm.

4. Place the blade of a small screwdriver

between the pins labelled "FACTORY RESTART".

A multi-tone sound indicates the engineers

passcode has been reset.

5. Replace the control panel cover. At the

remote keypad enter 1234. The display will

show “Engineers Menu 1". To change the

engineer’s passcode see ”Change Engineer’s

Passcode on page 36.

TS790 & TS900 Installation Manual Appendices

51

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 67 68

Komentarze do niniejszej Instrukcji

Brak uwag