Menvier Security TS510 Instrukcje Operacyjne Pobierz pdf (Strona 25)

Sending A Test Call

It is possible to test that each message plays to each telephone number e.g. you may want to test

that “Message A” plays to telephone number 1 or “Message B” to telephone number 3 etc.

Before sending a test call, make sure the person being called is familiar with the acknowledgement

procedure. This will ensure that the SD1+ is successfully cleared down.

The following example shows how to send “Message A” to telephone number 1:

Ensure that the SD1+ is initialised and the display is showing

“

” (see page 4).

Press A and the display will show “ ”.

Pressing or will select message B, C or D.

Press 1, to send message A to Telephone number 1.

Pressing at this point will send the message to all

programmed telephone numbers.

After the SD1+ has dialled out, it will attempt to detect a

ringing signal. If this signal is detected, the display will

show “

”. However, if this signal is not detected

within 5 seconds, the unit will automatically start to play

its message.

The unit will then play phrase 0 (Name & Address)

followed by phrase A (e.g. Fire Alarm). At the end of the

message, the person receiving the call should carry out

the call acknowledgement procedure (see page 14).

If the call is successfully acknowledged the display will

show “

”. If the person receiving the call fails to

acknowledge it on the first attempt the unit will repeat

the message four times, giving them the opportunity to

acknowledge the call at the end of each message.

However if at the end of the last attempt they still fail to

acknowledge the call the display will show "

and the unit will shut down.

Pressing ] at any time will abort the test call and return the unit

to the “

” prompt.

Repeat for message B, C or D, as required.

Repeat for other test call combinations as required.

1-4 / ENT

TO SEND

READY

SD1+

????

SEND A

TO NO 1

PHRASE A

PHRASE 0

RINGING

SENT OK

READY

Waiting Period

]

1 2 ... 20 21 22 23 24 25 26 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

Menvier Security TS510 Instrukcje Operacyjne Strona 25

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Menvier Security TS510