Menvier Security TS900+ Dokumentacja Pobierz pdf (Strona 58)

Defining Part-Set buttons to Arm a Ward(s)

This method of defining the part set groups

requires you to think of the system in terms of

separate areas of protection (Wards), then

configuring the part set groups so that different

combinations of wards are set.

1. From the previous part-set requirements assign

the different physical areas to wards, e.g.:

Ward A: Downstairs perimeter detection

(Circuits 01,04, 05 & 06).

Ward B:

Ward C: Bedroom 2 (Circuit 09).

2. Using the above ward requirements create a

Table for assigning circuits to wards. Circuits

with no ticks are assigned to the “System Ward”:

Circuit Location Ward A Ward B Ward C

01 Front Door

02 Smoke Detector

03 Hall door to garage

04 Garage door

05 Garage back door

06 Kitchen door

07 Dinning room PIR

08 Lounge PIR

09 Bedroom 2 PIR

10 Landing PIR

3. From the above Table assign circuits 01-10 to

their relevant wards (see “Configure Wards” on

page 37).

4. Program the part set groups, see “Part set

Groups”, on page 43. This ensures that when

the user selects button A, B or C the system

arms the correct wards. When using this

method, the part set groups are programmed

as follows:

Part Set Group A: [ AB ]

Part Set Group B: [ ABC]

Part Set Group C: [ A ]

This method will only work correctly if

circuits are assigned only to one ward.

If a circuit is assigned to more than one

ward, it will only be armed when all the

wards its assigned to are set.

54

Appendices TS790 & TS900 Installation Manual

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 67 68

Komentarze do niniejszej Instrukcji

Brak uwag